E-Frame Switch Mod

Originally posted by viperguy212(PBN)

1) Knock the pins that hold the switch, and the trigger, in place.

2) Take out the trigger, and then push the switch out into the the spot where the trigger was, keep all the wires connected.



3) Take a knife and pry open the little tabs on both sides of the switch to open it.

4) Now, if you look at the left side of the switch you will see a little arm holding the back end of the spring

5) Bend that little arm to the right. Note: the more you bend the lighter the pull will be. You can use a pen to bend it, but make sure not to bend it too far.



6) Put the top on the switch and install the trigger and switch with their respective pins.

7) Turn on your gun and feel the awesome pull