|
Quote
E-Frame Quick Trigger Mod
(From the trooper - PBN)
1. Take off the grip frame.
2. Bang the trigger pin out (from the right side of the gun) with a hammer and little screw driver. (it will be hard to do the first time)
3. Take out the spring
4. Put the trigger back in. (remember the star/* shaped side of the trigger pin should be on the left)
5. Loosen the screw (on the trigger) with quarter turns, then hold the body against the frame and squeeze tight. Pull the trigger to test it.
6. If you pull the trigger and nothing happens, do the same as #5, but tighten the screw instead of loosening it. The reason nothing is happening is because your switch is staying pressed.
7. Your trigger should rest on the switch, while the screw in the top of the trigger presses against the body of the gun. This eliminates the forward slack and holds the trigger in place against the switch.
8. When you get it set the way you like it, put a drop of BLUE Loc-tite on the toe screw and put your gun away over night; don't walk it til the next day. (the Loc-tite may run if you use too much and shake your gun around before it dries)
|