1. You can use High pressure pre-set tanks (800psi)on your angel. Do not use the low pressure preset tanks (450psi) unless you are using them on a speed or A4

2. Send at least 600psi (450 to 500 with a SPEED)into your angels minireg if you are using an adjustable tank. If you are using a gas-thru setup start at 300 psi and turn the output pressure up as needed to increase your velocity.

3. You can use the A.I.R., Maxflow, 2003 conquest or Armageddon for a single reg'ed system.

4. How can I turn my minireg into a gas-thru?
Unscrew the velocity adjuster until it is flush with the body of the minireg. You can also remove the ball bearing and spring stack to make it a true gas-thru. Both methods seem to work fine.

5. Oil your gun after every 8000 shots. 2 drops in the air-line going into the gun and 2 drops in the exhaust valve area under the breech.

6. My gun only clicks when I pull the trigger.
Your snapring is set to tight or something is blocking your bolt.

7. I only see the guns serial number or all 0's when I turn it on.
Your trigger is to close to the switch.

8. How do I charge my gun?
An LCD/IR3 must be in the ON position and and LED must be OFF before plugging the charger into the gun.

9. I am breaking paint.
Check your ball detent. There should be a small white ball in the metal housing. Make sure it is sticking out far enough. Rate of fire to fast for the hopper. Hopper is putting to much pressure on the balls in the breech and a second ball is trying to feed.(HALO issue)

10. It is a good idea to replace the snap o-ring during repeated adjustments. Once the o-ring has become stressed it will not perform correctly.